Planning system options 12 reset memory to the factory defaults 20.
Simon security system reset sensor.
Its components include a control panel and devices such as door and window sensors and smoke detectors as well as devices that respond to commands from the panel.
If the system is armed when the simon sensor is activated the alarm sound and emergency services may be called which depends on your setup.
The system is supervised meaning that the control panel checks the status of each sensor to detect problems.
Simon security system installation instructions document no.
466 1574 rev e dated march 1999.
Simon security systems are designed to be easily removed from one location and reinstalled into another location.
Press enter by programming then enter installer code 4321 then press ok.
The security system uses devices called sensors which use radio waves to communicate alarms to the control panel.
Battery change simon xt alarm panel duration.
Press siren options then uncheck trouble beeps then press close to exit.
Low system sensor battery alerts.
Enter your alarm code into the control panel to reset a sensor and disarm the alarm.
Decide how the sensors lights and system options will operate.
Simon security system press the arm motion sensors button twice.
Here are the steps on how to do it.
Programming a door sensor to the interlogix simon xti or xti 5 duration.
Check with your installer to find out how this option is programmed.
Using the simon xt security system 3 panel controls 3 simon xt features 5 home security 6 exit entry delay 8 bypassing sensors 9 alarms 10 chimes 11 latchkey 11 system status 12 using an offsite phone 12 touchpads and key fobs 13 how your system communicates 14 status beeps 14 alarm sirens 15 panel indicator lights 15.
Since simon alarm systems are typically installed as wireless systems removing them takes about an hour or so.
A simon xt alarm is a security system that works as an intrusion alarm system and can offer fire warning and emergency notification or any combination of the three.
Enter your master code.
Press bottom right gear icon then press down arrow several times.
Code 1 2 button twice and the 3 4 button twice to enter that access code.
On your simon xt scroll to system test with the arrow keys to the right of your screen.
The display should read sensor test press ok.
Retrieve the system status.
Program the sensors lights and appliances and.
1 fcc notices.
Access code lengths need to be between 3 and 6 digits and are set by the installer.
If the status is still not clear the last step is to perform a sensor test.
Press close again to exit programming.
