Whether for slate shingle or metal roofing valley flashing adds detail and helps to direct water.
Slate roof valley flashing.
Intersecting roofs using a closed valley must have the same slopes so that the shingle butts line up at the valley intersection.
The installer fabricates simple clips or valley flashing cleats whose bent edge interlocks with the folded over or hemmed edges of the metal roof valley flashing to secure the valley to the roof deck.
Roof valley flashing material options there is a lot of misinformation and confusion out there when it comes to properly waterproofing roof valleys.
Lap successive sheets of metal flashing a minimum of 12 inches and seal laps.
Using clips permits movement in the valley as temperatures change.
The first step to installing an open valley is to cleat your valley metal in.
Missing ice water shield.
As this weak spot on your roof directs large amounts of water it is a common source for leaks.
The cleats accommodate thermal movement in the valley flashing to prevent stress cracks.
Brent ulisky of ulisky slate demonstrates flashing a closed valley at the 2015 slate roofing contractors association 10th anniversary conference near grove.
There are many factors that can contribute towards a failure of a roof valley flashing.
Use roof valley cleats at intervals of 24 o c.
Made with premium steel 28 gauge limited lifetime paint warranty easy to cut.
Diagonal cuts can be made to the top corner of these slates in the valley so the pointy edge does not damage the metal.
Install an underlayment centered in the roof valley.
For roof pitches of 6 or more per foot the flashing extends at least 9 under the roof covering on each side.
Structural issues inadequate construction improper roofing methods and material deterioration.
These items can be fabricated in many different profiles.
A properly flashed roof valley should have an ice and water shield installed with roofing felt being properly secured over the ice and water.
Common causes of roof valley leaks.
Valley flashing is used for flashing where roof valleys are constructed.
For roof pitches less then 6 per foot the flashing extends at least 12.
Then install a non corrosive metal valley flashing of 24 minimum width.
Apply an approximately 3 inch width of asphalt roofing cement along the sides of flashing and embed shingles in mastic.
