Did it cut cleanly through the vinyl.
Silhouette blade cutting through vinyl backing.
This video shows how i resolved a silhouette vinyl cutting issue.
Just remove the blade from the carriage put it blade side down into the indention and turn until the blade is on the setting you want.
My friend and fellow instructor elly from silhouette secrets has diagnosed this issue so often on facebook that she keeps a photo of a properly installed blade on hand to post whenever someone is having cutting issues.
To cut properly the blade must be pushed all the way down with no visible gap between the tool holder and the blade.
For me this is the bane of using vinyl.
Can the triangle be removed completely without any places sticking.
Did the machine cut all the way through to the back.
Once the cut is finished use the unload button on your machine to unload your vinyl.
If your cricut cuts through the backing there are usually one of two possible issues.
How to stop cutting through vinyl backing.
In most cases there are two quick fixes that will fix the issue and get you cutting successfully in a hurry.
Blade ratchet to change blade setting on each machine made in the last 3 years or so there is a round indentation on the machine in the lower left hand side.
I sure hope it works.
Once the vinyl is removed look at your test cut.
Trying out new vinyl or felt a blunt blade or any other number of reasons.
I can use an older style ratchet blade in the adapter and it will cut fine.
Place the vinyl onto the silhouette cutting mat with the backing paper side down onto the mat making sure the vinyl is covering the same area where the design is placed on the virtual mat in silhouette studio.
1 blade is not properly inserted and or locked down.
Silhouette finally has more autoblades available and is sending me a new one.
It took me a long time to get it right and i often have to make small adjustments for various reasons ie.
This is a tool you can use to change the setting on the blade.
If you ve just replaced your blade and are having this problem you probably have the wrong blade.
The same goes for the portrait 2 autoblade.
When cutting adhesive vinyl or heat transfer vinyl a kiss cut is used to cut the vinyl but leave the carrier sheet or backing intact.
If this happened the blade is cutting too deep.
